How to install lawn lights?
May 07, 2024
How to install lawn lights:
1. The first step in installing a lawn lamp is to check if all the accessories of the lawn lamp are complete and can be used normally.
2. The second step in installing lawn lights is to embed pipelines. People should bury pipes and wires according to the circuit diagram, and then pour the foundation. Before pouring the foundation, people need to lead out the embedded pipelines to facilitate the later connection of lighting fixtures.
3. The third step in installing lawn lights is to install them. People should refer to the lawn lamp manual, assemble the lamp, and then align the lawn lamp flange with the foundation embedded screw, standing vertically. Then use nuts or shims to level and tighten the installation nuts. Finally, the wiring installation is completed.
4. The fourth step in installing lawn lights is to power on and conduct a trial run. After the installation of the lawn lamp is completed, it is allowed to power on for trial operation. After power on, check whether the control of the lawn lamp is flexible and accurate, and whether the control sequence of the lamps is corresponding. If any problems are found, power should be cut off, and the cause should be identified and resolved.
